ATC

Stick the ramp supports (the two bits with anchors on (inside)) in the front with the gentle slopes outward. The vertical side in with a bend half way up inward to the boat.

Stick the front ramp on the front of these, the bottom of the ramp should touch the base/ground.

Stick the resin superstructure on top with the three drill holes toward the back.

The three turrets, go in the three holes (drill them out larger or lop off the locating pins as you prefer).

Stick the two long bars with ridges on each side of the front well deck (between the ramp holders and the superstructure). ridges out - these are the supports for the Canvas Tilt. Paint the gaps black.

Glue the Canvas Tilt on top (or leave off if you want to place minitures in the well deck) maybe put two
strips of plastic underneath to locate the Canvas tilt when you put it on in play.

Put the two small metal bits right at the back, with a small gap between right butted up against the back.

The small winch with two cylinders goes at the back just hanging over the two small metal bars. If you
want you can detail with some drag chain (use 1mm stuff).

Hope that covers everything - enjoy your model

Monitor/CCB

Drill out the flat plate to allow the main gun to go into it, Glue this onto the front of the front turret on the opposite face to the door. Glue this in position on the raised cicle on the front.

Stick together the two halves of the direct fire mortar and glue into the centre of the depressed well deck.

Stick the resin superstructure on top with the three drill holes toward the back.

Stick the radar dish, (small circle with bent rod out the bottom) centrally in front of the wheelhouse.

The three turrets, go in the three holes (drill them out larger or lop off the locating pins as you prefer).

For the CCB version glue Canvas Tilt on top instead of inserting the mortar (this is the tent like object pictured on the top right hand corner)

Put the two small metal bits right at the back, with a small gap between right butted up against the back.

The small winch with two cylinders goes at the back just hanging over the two small metal bars. If you
want you can detail with some drag chain (use 1mm stuff).

Hope that covers everything - enjoy your model

PACV NEW PIC SHORTLY - I PROMISE

Stick engine cowling on top (long thing bit - pointy end toward back). (drill hole in pointy bit first if you want to).

Stick turret on top (in front of engine cowling)

Stick the radar assembly on the top of engine cowling just where it goes flat.

Stick twin guns on front of turret (you can file to make it point in air if looks better). You can cut down a suitable fig to sit in it if you like).

Stick two flappy things horizontal between the two tail fins and stick on back between the two big boxes. So it is sloped backward.